The Preset 10 Architectural is a DMX512 playback device that can take up to ten snapshots from a DMX console and play them back at the press of a button. Fade times can be set from 0 to 999 seconds (default is 2 seconds). Mounts into a single gang back box (Raco Handy Box 670RAC is included).
There are two versions of software available: PRE10-A and PRE10-A-POPO. The original PRE10-A offers "Radio Button" operation, where only one preset may be active at time. The new PRE10-A-POPO offers ten HTP presets. Each of these ten HTP presets are capable of being turned ON or OFF individually.
Doug Fleenor Design Preset 10 Architectural Features
- Available in black and white
- Capable of storing up to ten presets
- Presets are recorded by capturing the output of a DMX512 console
- Each preset can then be assigned a unique fade time, from 0 to 999 seconds
- Presets are recalled by pressing one of the buttons
- Systems can be created by using one or more stations and a power supply
- Solid aluminum faceplate installs over a standard single gang electrical box
- Connections to the Preset 10 Architectural are power (2 wires) and DMX512 (3 wires)
- Power can be supplied from a variety of sources, including a 10V class 2 "doorbell" transformer
- System can works in conjunction with a lighting console, automatically switching between preset and console control
- Preset 10 Architectural DMX Controller1
- Connector
- Phoenix Contact MSTB series 5 position two part terminal block
- Model: MSTB 2,5/5-ST-5,08 Order Number: 17 57 04 8
- Connector pin out
- 1: DMX512 common
- 2: DMX512 data -
- 3: DMX512 data +
- 4: Supply common (tied to pin1)
- 5: Supply “hot”
- Input/Output circuitESD protected EIA-485 transceiver (LT1785)
- Input signalDMX512, DMX512/1990, DMX512-A, or RDM
- Indicators
- Ten green preset indicator LEDs
- One red Lockout / Record LED
- One yellow fade time LED
- User controls
- Ten preset push buttons
- One recessed record push button
- One recessed fade time push button
- Option jumpers
- Main / Remote mode selection
- Pervious preset / Hold last look mode selection
- Power input
- 9 to 15 volts AC or DC / 200mA per station
- (A 10 volt class 2 “doorbell” transformer is recommended for fixed installations)
- ColorBlack anodized with silver engraved nomenclature
- Size
- Faceplate (HxDxW): 4.5×0.2×2.75"
- Faceplate: rear inset (HxDxW): 4.05×0.1×2.4"
- Electrical box minimum inside dimensions (HxDxW): 3.5×1.25×2.1"
- Included back box: Raco 670RAC
