Digital Audio Labs AD-24 24-Channel Analog Input Rack Unit

If you have an analog based system, the AD-24 Analog Input Rack Unit takes your analog signals and converts them to digital, for use in the Livemix system. It will most likely be installed near the analog source. If this is your mixer’s Direct Outs or Inserts, then the AD-24 will be near the mixer. If you use a snake with mic preamps, it might be near the snake.

The AD-24 receives your input signal via TRS or DB-25. The inputs pass through, so you can send your audio to the AD-24 via DB-25, and back out through the TRS if required.

The front panel interface indicates input signal levels by LED and allows selection of -10 dBV or +4 dBu line level, which are in stereo pairs.

Digital Audio Labs AD-24 Features

• 24 Balanced/Unbalanced Inputs
• 1/4" & DB-25 Connectors
• Front Panel VU
• Front panel +4dBu/-10dBV switches
• High Quality Audio Conversion

• AD-24 24-Channel Analog Input Rack Unit1

• THD+N0.001%
• S/N Ratio 111 dB
• Frequency Response 20 Hz – 22KHz ± .5dB
• Crosstalk -92 dB
• Maximum Input Level +24 dBu (minor distortion above 23.5 dBu, hard clip at +24 dBu)
• Input Impedance 20KΩ Balanced, 10KΩ Unbalanced
• Max cable length to MIX-16/MIX32 100m CAT5e cable (shielded required)