A complete stereo pair; two DPA ST2011A Cardioid Condenser Microphones, selected on sensitivity within ±1.5 dB. Makes several stereo principles like XY and ORTF easy to obtain.
These mics are acclaimed for their close-miking excellence and hi-SPL handling. Optimized for onstage use, it has been used on many stages as well as recording sessions. They exhibit a previously unheard blend of clarity, richness and dynamic range. The off-axis response is linear but in a smaller frequency bandwidth. This makes stage separation and gain-to-feedback higher. The mic level is easier to control.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays.
DPA ST2011A Features
- Sensitivity-selected pair
- Blends clarity, richness and dynamics
- Twin diaphragm capsule and interference tube technologies
- Superb stage separation and level control
- Low-profile mounting options
- Modular flexibility
- Peli Case transportation and protection
- 2011A twin diaphragm cardioid microphones2
- Clips2
- Windscreens2
- Carry case1
- Transducer TypeCondenser
- Polar PatternCardioid
- Frequency Response20 Hz - 20 kHz
- Rated Output Impedance200 ohms
- Sensitivity, Nominal ±2 dB at 1 kHz10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent Noise Level, A-Weightedtyp. 20 dB(A) re. 20 µPa (max. 23 dB(A))
- Equivalent Noise Level, ITU-R BS.468-4typ. 33 dB (max. 36 dB)
- Distortion, THD < 1%134 dB SPL RMS, 137 dB SPL peak
- Dynamic Rangetyp. 117 dB
- Max. SPL, THD 10%153 dB SPL peak
- Switchable Attenuator, Filters, etc.0 dB / -20 dB
- Cable Drive Capability100 m (328 ft)
- Output Balance PrincipleImpedance balancing with Active Drive
- CMRR> 60 dB
- Power Supply (for full performance)P48 (Phantom Power)
- Current consumption2.8 mA
- ConnectorXLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Weight5.8 oz
- Dimensions0.75x7.8"
- Max. Output Voltage, RMS8V
- Sensitivity Selection Tolerance (at 1kHz)±1.5 dB