A complete Stereo Pair with this pair of carefully factory-matched d:dicate ST4015C Wide Cardioid Microphones. Even though the standard tolerances on d:dicate series are extremely low, a stereo match is even closer. These mics are matched within ±1 dB on both frequency response and sensitivity.
Visually discreet, the d:dicate 4015C Wide Cardioid Microphone, Compact represents an indispensably low-profile solution for audio engineers and set designers alike. Tremendously precise and natural sounding, these mics will certainly exceed expectations when used on choirs, percussion setups, grand pianos, wind instruments and much more.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays.
DPA ST4015C Features
- Low profile - wide pickup area
- Natural reproduction
- Directional ambience pickup
- Carefully matched within ±1 dB
- Peli Case transportation and protection
- Modular flexibility
- 4015C wide cardioid microphones2
- Windscreens2
- Clips2
- Carry case1
- Transducer TypeCondenser
- Polar Patternwide cardioid
- Frequency Response20 Hz - 20 kHz
- Rated Output Impedance100 ohms
- Sensitivity, Nominal ±2 dB at 1kHz10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent Noise Level, A-Weightedtyp. 18 dB(A) re. 20 µPa (max. 20 dB(A))
- Equivalent Noise Level, ITU-R BS.468-4typ. 25 dB (max. 27 dB)
- Distortion, THD < 1%136 dB SPL RMS, 139 dB SPL peak
- Dynamic Rangetyp. 121 dB
- Max. SPL, THD 10%152 dB SPL peak
- Cable Drive Capability100 m (328 ft)
- Output Balance PrincipleImpedance balancing with Active Drive
- CMRR> 50 dB
- Power Supply (for full performance)P48 (Phantom Power)
- Current Consumption2.8 mA
- ConnectorXLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Colormatte black
- Weight2 oz
- Dimensions0.75" diameter x 2.5" length
- Max. Output Voltage, RMS4.5 V
- Matching Tolerance (frequency response and sensitivity)±1 dB
- Phase Deviation for Kit< 10°
