Dimensions
Dimensions (WxDxH)
10.26x6.14x1.91" (260.6x155.95x48.51 mm)
Plug Size
2 mm
Dimensions
19" (482.6 mm) wide x 5.75" (146 mm) deep; 1U high
Electrical
THD +n
< 0.003%
Audio
Audio Output
1/4" TRS stereo, headphone or line level
Headphone Output
275 mW per side into 50 Ohms (both sides driven)
Output Impedance
5 Ohms
Audio Inputs
16, balanced line-level, 1/4-inch TRS connector
Frequency Response
4Hz-22kHz
Gain Settings
Four-position switch, -10dBv, 0dBu, +4dBu, and +22dBu
Maximum Input Level
+22dBu
Input Impedance
17.8k ohm
Crosstalk
-90dB
Output Voltage
18-24 VDC, 0.5 amp
Connectivity
Stereo Mix Output, Headphone/Line Tip
Audio LeftRing: Audio RightSleeve: Ground
Cat-5 Cable
Use shielded Cat-5e (or better) cable to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
Inputs
Tip: Audio +; Ring: Audio -; Sleeve: Ground
Line Inputs
Impedance: 48k ohms
Digital Outputs
A-Net: 1; RJ45 connector
A-Net Cables
Front Panel Connections: Shielded Cat-5e (or better) cable must be used to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits. Unshielded Cat-5e cable may be used on all rear panel connections
Shipping
Weight
1.3 lb (0.59 kg)
General
A320 Specifications
A-Net I/O 1 A-Net In, RJ45 connectorSupports Pro16 and Pro16e, Stereo Operation Stereo Link, per channel pairSet at the input moduleVariable pan per mono channel or pan/spread per stereo channel pair, Output Voltage for Personal Mixers 24VDC, 0.5 ampTransmitted over the Cat-5e cable, Pro16e A-Net Use Cat-5e (or better) cableMaximum 400 ft (122 m) between devicesSupports Power Over A-Net, Power 24 VDC, 0.5 ampPower is supplied over the Cat-5 cable when connected to an Aviom A-Net Distributor
D/A Conversion
44.1/48kHz, 24-bit
Freq. Response
3Hz-22kHz +0.2dB/-3dB at 50 Ohms
Signal to Noise (unweighted)
-106dB (measured with zero data into all channels)
TRS Thru
Impedance matched output
Analog to Digital Conversion
48kHz sample rate, 24 bit
AN-16/i v.2 Specifications
A- Net In One Category 5 (RJ45 connector)Four-position slot range selector switch for use with Pro16e A-Net, Stereo Operation Stereo Link, per channel pairTwo-position switch (Normal, Link), Signal to Noise (unweighted) 90dB typical, A/D to D/AMeasured from AN-16/i to AN-16/o Output Module
A-Net Out
One Category 5 (RJ45 connector)
Channel LED Indicators
Signal Present and Clip, per channel
Metering
LEDs; green: Signal Present, red: Clip; per channel
Bit Error Rate (BER)
10(-12)
Pro16e A-Net
Use unshielded Cat-5e UTP (or better) cable
Power Supply
External, DC, universal switching type
D400 Specifications
A-Net Input Pro16 or Pro16e A-NetRJ45 connector, A-Net Out Pro16e A-NetRJ45 connector, unpowered, Output Voltage for Personal Mixers 24VDC, 0.5 ampTransmitted over the Cat-5e cable
A-Net Offset Base Slot
2-position DIP switch selects the starting channel that Personal Mixers will receive from the network (1, 17, 33, or 49)
Defeat Stereo Switches
Chooses between local (front panel) stereo links (up) or network stereo links (down)
A-Net Out to Personal Mixers
Eight RJ45 connectors, powered
Stereo Link
Two 8-position DIP switch blocks (1-16, 17-32)
AC Fuse Types 115V Range
T2.5AL/250V230V range: T1.25AL/250V
Audio Performance
Latency
0.880 msec (measured from analog input to analog output)
Power
Input Voltage
100-240 volts, 50/60Hz, 30VA
Power
18-24 VDC, 500mA
Indicators
LEDs
Power On (red); Network Sync (green)
