Skip to product information
1 of 2

Q-SYS DCA2422 2-Channel Cinema Power Amplifier

Q-SYS DCA2422 2-Channel Cinema Power Amplifier

SoundPro Item: 119386 | Part Number: DCA2422

Pricing available upon request

Pricing available upon request

Your Price Sold out

Usually ships in 5-7 business days

  • 2-Step H Output Circuitry Maximizes Efficiency Across Low-Impedance Cinema Loads
  • DataPort Interface Enables Direct Integration With DCP And DCM Cinema Processors
  • Exclusive PowerLight Power Supply Sustains Extended Low-Frequency Output
  • Active Inrush Limiting Prevents Circuit Breaker Trips At Power-On
  • Gain Control Security Cover Guards Against Tampering In Unattended Installations
  • Patented Output Averaging Short Circuit Protection Safeguards Amplifier And Loads
  • Neutrik Speakon And Safety-Shrouded Barrier Strip Outputs Plus Monitor Panel Connectors

The Q-SYS DCA2422 is a two-channel fixed-installation power amplifier engineered specifically for commercial cinema environments where consistent headroom, network integration, and rack density are operational requirements. Its 2-Step H output class sustains rated EIA power from 8 ohms down to 2 ohms and bridges cleanly into 8 ohm mono loads, covering main screen channels, surround arrays, and subwoofer drive within a single 2U chassis that fits standard 14-inch deep racks. For cinema operators building high-density amplifier rooms, this combination of low-impedance capability and compact form factor eliminates the need for custom rack infrastructure.

The DataPort interface is the feature that separates the DCA2422 from generic installed amplifiers. It enables direct integration with QSC DCP Digital Cinema Processors and DCM Digital Cinema Monitors, supporting networked and managed signal chains that commercial cinema installations require. The exclusive PowerLight power supply sustains extended low-frequency output without rail sag, and a hum-free noise floor exceeding 108 dB SNR unweighted preserves the dynamic range that critical listening environments demand. Variable-speed rear-to-front fan cooling maintains chassis quiet during dialogue-heavy content while handling thermal load during high-output sequences.

For installation teams, the DCA2422 includes active inrush limiting to prevent circuit breaker trips at power-on, a gain control security cover that protects settings in unattended equipment rooms, and patented output averaging short circuit protection that safeguards both the amplifier and connected loads. Input flexibility spans balanced XLR, quarter-inch TRS, and detachable terminal block per channel, with Neutrik Speakon and safety-shrouded barrier strip outputs covering standard cinema wiring practices.

Downloads

View full details

Specifications

Audio
Channels
2
Output Circuitry Class
2-Step H
Power Output (8Ω, 20 Hz-20 kHz, 0.03% THD)
425 W per channel
Power Output (4Ω, 20 Hz-20 kHz, 0.05% THD)
700 W per channel
EIA Power @ 8Ω (1 kHz, 1% THD)
475 W
EIA Power @ 4Ω (1 kHz, 1% THD)
825 W
EIA Power @ 2Ω (1 kHz, 1% THD)
1200 W
Bridged Mono @ 16Ω (20 Hz-20 kHz, 0.1% THD)
850 W
Bridged Mono @ 8Ω (20 Hz-20 kHz, 0.1% THD)
1500 W
Bridged Mono @ 4Ω (1 kHz, 1% THD)
2400 W
Signal to Noise Ratio (20 Hz-20 kHz, unweighted)
> 108 dB
Input Sensitivity @ 8Ω
1.5 V rms (+5.5 dBu)
Input Sensitivity @ 4Ω
1.3 V rms (+4.6 dBu)
Frequency Response (LF filter off)
20 Hz-20 kHz, ± 0.2 dB; 8 Hz-50 kHz, +0/-3 dB
Damping Factor (1 kHz and below)
Greater than 500
Distortion SMPTE-IM
< 0.02%
Distortion THD (20 Hz-20 kHz, 10 dB below rated power)
Less than 0.01% @ 8 and 4Ω
Distortion THD (1.0 kHz and below, full rated power)
Less than 0.01% @ 8 and 4Ω
Input Impedance
10 kΩ unbalanced, 20 kΩ balanced
Input Clipping
10 V rms (+22 dBu)
Voltage Gain @ 8Ω
40x (32 dB)
Connectivity
Input Connectors (per channel)
1/4" TRS, 3-pin XLR, 3-pin detachable terminal block
Output Connectors (per channel)
Neutrik Speakon, safety-shrouded barrier strip, Monitor output
DataPort Connector
One HD15
Controls
Front Panel
AC switch, Ch. 1 and Ch. 2 recessed gain knobs
Rear Panel DIP Switches
Clip Limiter on/off per channel; LF Filter on/off per channel; LF Filter Freq 30 or 50 Hz per channel; Inputs Parallel or Stereo; Bridge Mode
Indicators
Per Channel LEDs
CLIP/PROT (Red); LEVEL -10 dB (Green); LEVEL -20 dB (Green); SIGNAL -35 dB (Green); BRIDGED (Yellow); PARALLEL INPUTS (Yellow); POWER (Green)
Construction
Cooling
Variable-speed fan, rear-to-front air flow
Amplifier Protection
Full short circuit, open circuit, thermal, ultrasonic, and RF protection; stable into reactive or mismatched loads
Load Protection
On/off muting, DC-fault power supply shutdown
Dimensions
Dimensions HWD (inches)
3.5" x 19" x 14"
Dimensions HWD (mm)
89 x 483 x 356
Weight
Net Weight
21 lbs (9.5 kg)
Identifiers
Model
DCA2422

Why Choose SoundPro?

Since 1972, SoundPro has been the trusted source for audio, video, and lighting gear. Whether you're starting your AVL journey or are a seasoned professional, we're here to help you every step of the way.

  • Certified Account Managers

    Our Account Managers, with 16+ industry certifications, are ready to find your solution.

  • Personalized Pricing

    We know every project is unique. Get a personalized quote anytime you need it

  • Fast Shipping & Local Pickup

    In stock items ship same day if ordered by 4pm CST. Pickup offered in Irving, TX.

  • Accountability from Real People

    We aim for a smooth, transparent experience by setting and sticking to clear expectations.

  • Easy Payments & Financing

    We accept all major credit cards and also offer financing through our partners.

1 of 2